1 /*
2 * linux/sound/oss/waveartist.h
3 *
4 * def file for Rockwell RWA010 chip set, as installed in Rebel.com NetWinder
5 */
6
7 //registers
8 #define CMDR 0
9 #define DATR 2
10 #define CTLR 4
11 #define STATR 5
12 #define IRQSTAT 12
13
14 //bit defs
15 //reg STATR
16 #define CMD_WE 0x80
17 #define CMD_RF 0x40
18 #define DAT_WE 0x20
19 #define DAT_RF 0x10
20
21 #define IRQ_REQ 0x08
22 #define DMA1 0x04
23 #define DMA0 0x02
24
25 //bit defs
26 //reg CTLR
27 #define CMD_WEIE 0x80
28 #define CMD_RFIE 0x40
29 #define DAT_WEIE 0x20
30 #define DAT_RFIE 0x10
31
32 #define RESET 0x08
33 #define DMA1_IE 0x04
34 #define DMA0_IE 0x02
35 #define IRQ_ACK 0x01
36
37 //commands
38
39 #define WACMD_SYSTEMID 0x00
40 #define WACMD_GETREV 0x00
41 #define WACMD_INPUTFORMAT 0x10 //0-8S, 1-16S, 2-8U
42 #define WACMD_INPUTCHANNELS 0x11 //1-Mono, 2-Stereo
43 #define WACMD_INPUTSPEED 0x12 //sampling rate
44 #define WACMD_INPUTDMA 0x13 //0-8bit, 1-16bit, 2-PIO
45 #define WACMD_INPUTSIZE 0x14 //samples to interrupt
46 #define WACMD_INPUTSTART 0x15 //start ADC
47 #define WACMD_INPUTPAUSE 0x16 //pause ADC
48 #define WACMD_INPUTSTOP 0x17 //stop ADC
49 #define WACMD_INPUTRESUME 0x18 //resume ADC
50 #define WACMD_INPUTPIO 0x19 //PIO ADC
51
52 #define WACMD_OUTPUTFORMAT 0x20 //0-8S, 1-16S, 2-8U
53 #define WACMD_OUTPUTCHANNELS 0x21 //1-Mono, 2-Stereo
54 #define WACMD_OUTPUTSPEED 0x22 //sampling rate
55 #define WACMD_OUTPUTDMA 0x23 //0-8bit, 1-16bit, 2-PIO
56 #define WACMD_OUTPUTSIZE 0x24 //samples to interrupt
57 #define WACMD_OUTPUTSTART 0x25 //start ADC
58 #define WACMD_OUTPUTPAUSE 0x26 //pause ADC
59 #define WACMD_OUTPUTSTOP 0x27 //stop ADC
60 #define WACMD_OUTPUTRESUME 0x28 //resume ADC
61 #define WACMD_OUTPUTPIO 0x29 //PIO ADC
62
63 #define WACMD_GET_LEVEL 0x30
64 #define WACMD_SET_LEVEL 0x31
65 #define WACMD_SET_MIXER 0x32
66 #define WACMD_RST_MIXER 0x33
67 #define WACMD_SET_MONO 0x34
68
69 /*
70 * Definitions for left/right recording input mux
71 */
72 #define ADC_MUX_NONE 0
73 #define ADC_MUX_MIXER 1
74 #define ADC_MUX_LINE 2
75 #define ADC_MUX_AUX2 3
76 #define ADC_MUX_AUX1 4
77 #define ADC_MUX_MIC 5
78
79 /*
80 * Definitions for mixer gain settings
81 */
82 #define MIX_GAIN_LINE 0 /* line in */
83 #define MIX_GAIN_AUX1 1 /* aux1 */
84 #define MIX_GAIN_AUX2 2 /* aux2 */
85 #define MIX_GAIN_XMIC 3 /* crossover mic */
86 #define MIX_GAIN_MIC 4 /* normal mic */
87 #define MIX_GAIN_PREMIC 5 /* preamp mic */
88 #define MIX_GAIN_OUT 6 /* output */
89 #define MIX_GAIN_MONO 7 /* mono in */
90
91 int wa_sendcmd(unsigned int cmd);
92 int wa_writecmd(unsigned int cmd, unsigned int arg);
93
|
This page was automatically generated by the
LXR engine.
|