Linux kernel & device driver programming

Cross-Referenced Linux and Device Driver Code

[ source navigation ] [ diff markup ] [ identifier search ] [ freetext search ] [ file search ]
Version: [ 2.6.11.8 ] [ 2.6.25 ] [ 2.6.25.8 ] [ 2.6.31.13 ] Architecture: [ i386 ]
  1 /*
  2  * drivers/usb/host/ehci-orion.c
  3  *
  4  * Tzachi Perelstein <tzachi@marvell.com>
  5  *
  6  * This file is licensed under  the terms of the GNU General Public
  7  * License version 2. This program is licensed "as is" without any
  8  * warranty of any kind, whether express or implied.
  9  */
 10 
 11 #include <linux/kernel.h>
 12 #include <linux/module.h>
 13 #include <linux/platform_device.h>
 14 #include <asm/arch/orion.h>
 15 
 16 #define rdl(off)        __raw_readl(hcd->regs + (off))
 17 #define wrl(off, val)   __raw_writel((val), hcd->regs + (off))
 18 
 19 #define USB_CAUSE               0x310
 20 #define USB_MASK                0x314
 21 #define USB_CMD                 0x140
 22 #define USB_MODE                0x1a8
 23 #define USB_IPG                 0x360
 24 #define USB_PHY_PWR_CTRL        0x400
 25 #define USB_PHY_TX_CTRL         0x420
 26 #define USB_PHY_RX_CTRL         0x430
 27 #define USB_PHY_IVREF_CTRL      0x440
 28 #define USB_PHY_TST_GRP_CTRL    0x450
 29 
 30 /*
 31  * Implement Orion USB controller specification guidelines
 32  */
 33 static void orion_usb_setup(struct usb_hcd *hcd)
 34 {
 35         /*
 36          * Clear interrupt cause and mask
 37          */
 38         wrl(USB_CAUSE, 0);
 39         wrl(USB_MASK, 0);
 40 
 41         /*
 42          * Reset controller
 43          */
 44         wrl(USB_CMD, rdl(USB_CMD) | 0x2);
 45         while (rdl(USB_CMD) & 0x2);
 46 
 47         /*
 48          * GL# USB-10: Set IPG for non start of frame packets
 49          * Bits[14:8]=0xc
 50          */
 51         wrl(USB_IPG, (rdl(USB_IPG) & ~0x7f00) | 0xc00);
 52 
 53         /*
 54          * GL# USB-9: USB 2.0 Power Control
 55          * BG_VSEL[7:6]=0x1
 56          */
 57         wrl(USB_PHY_PWR_CTRL, (rdl(USB_PHY_PWR_CTRL) & ~0xc0)| 0x40);
 58 
 59         /*
 60          * GL# USB-1: USB PHY Tx Control - force calibration to '8'
 61          * TXDATA_BLOCK_EN[21]=0x1, EXT_RCAL_EN[13]=0x1, IMP_CAL[6:3]=0x8
 62          */
 63         wrl(USB_PHY_TX_CTRL, (rdl(USB_PHY_TX_CTRL) & ~0x78) | 0x202040);
 64 
 65         /*
 66          * GL# USB-3 GL# USB-9: USB PHY Rx Control
 67          * RXDATA_BLOCK_LENGHT[31:30]=0x3, EDGE_DET_SEL[27:26]=0,
 68          * CDR_FASTLOCK_EN[21]=0, DISCON_THRESHOLD[9:8]=0, SQ_THRESH[7:4]=0x1
 69          */
 70         wrl(USB_PHY_RX_CTRL, (rdl(USB_PHY_RX_CTRL) & ~0xc2003f0) | 0xc0000010);
 71 
 72         /*
 73          * GL# USB-3 GL# USB-9: USB PHY IVREF Control
 74          * PLLVDD12[1:0]=0x2, RXVDD[5:4]=0x3, Reserved[19]=0
 75          */
 76         wrl(USB_PHY_IVREF_CTRL, (rdl(USB_PHY_IVREF_CTRL) & ~0x80003 ) | 0x32);
 77 
 78         /*
 79          * GL# USB-3 GL# USB-9: USB PHY Test Group Control
 80          * REG_FIFO_SQ_RST[15]=0
 81          */
 82         wrl(USB_PHY_TST_GRP_CTRL, rdl(USB_PHY_TST_GRP_CTRL) & ~0x8000);
 83 
 84         /*
 85          * Stop and reset controller
 86          */
 87         wrl(USB_CMD, rdl(USB_CMD) & ~0x1);
 88         wrl(USB_CMD, rdl(USB_CMD) | 0x2);
 89         while (rdl(USB_CMD) & 0x2);
 90 
 91         /*
 92          * GL# USB-5 Streaming disable REG_USB_MODE[4]=1
 93          * TBD: This need to be done after each reset!
 94          * GL# USB-4 Setup USB Host mode
 95          */
 96         wrl(USB_MODE, 0x13);
 97 }
 98 
 99 static int ehci_orion_setup(struct usb_hcd *hcd)
100 {
101         struct ehci_hcd *ehci = hcd_to_ehci(hcd);
102         int retval;
103 
104         retval = ehci_halt(ehci);
105         if (retval)
106                 return retval;
107 
108         /*
109          * data structure init
110          */
111         retval = ehci_init(hcd);
112         if (retval)
113                 return retval;
114 
115         ehci_reset(ehci);
116         ehci_port_power(ehci, 0);
117 
118         return retval;
119 }
120 
121 static const struct hc_driver ehci_orion_hc_driver = {
122         .description = hcd_name,
123         .product_desc = "Marvell Orion EHCI",
124         .hcd_priv_size = sizeof(struct ehci_hcd),
125 
126         /*
127          * generic hardware linkage
128          */
129         .irq = ehci_irq,
130         .flags = HCD_MEMORY | HCD_USB2,
131 
132         /*
133          * basic lifecycle operations
134          */
135         .reset = ehci_orion_setup,
136         .start = ehci_run,
137 #ifdef CONFIG_PM
138         .suspend = ehci_bus_suspend,
139         .resume = ehci_bus_resume,
140 #endif
141         .stop = ehci_stop,
142         .shutdown = ehci_shutdown,
143 
144         /*
145          * managing i/o requests and associated device resources
146          */
147         .urb_enqueue = ehci_urb_enqueue,
148         .urb_dequeue = ehci_urb_dequeue,
149         .endpoint_disable = ehci_endpoint_disable,
150 
151         /*
152          * scheduling support
153          */
154         .get_frame_number = ehci_get_frame,
155 
156         /*
157          * root hub support
158          */
159         .hub_status_data = ehci_hub_status_data,
160         .hub_control = ehci_hub_control,
161         .bus_suspend = ehci_bus_suspend,
162         .bus_resume = ehci_bus_resume,
163 };
164 
165 static int __init ehci_orion_drv_probe(struct platform_device *pdev)
166 {
167         struct resource *res;
168         struct usb_hcd *hcd;
169         struct ehci_hcd *ehci;
170         void __iomem *regs;
171         int irq, err;
172 
173         if (usb_disabled())
174                 return -ENODEV;
175 
176         pr_debug("Initializing Orion-SoC USB Host Controller\n");
177 
178         irq = platform_get_irq(pdev, 0);
179         if (irq <= 0) {
180                 dev_err(&pdev->dev,
181                         "Found HC with no IRQ. Check %s setup!\n",
182                         pdev->dev.bus_id);
183                 err = -ENODEV;
184                 goto err1;
185         }
186 
187         res = platform_get_resource(pdev, IORESOURCE_MEM, 0);
188         if (!res) {
189                 dev_err(&pdev->dev,
190                         "Found HC with no register addr. Check %s setup!\n",
191                         pdev->dev.bus_id);
192                 err = -ENODEV;
193                 goto err1;
194         }
195 
196         if (!request_mem_region(res->start, res->end - res->start + 1,
197                                 ehci_orion_hc_driver.description)) {
198                 dev_dbg(&pdev->dev, "controller already in use\n");
199                 err = -EBUSY;
200                 goto err1;
201         }
202 
203         regs = ioremap(res->start, res->end - res->start + 1);
204         if (regs == NULL) {
205                 dev_dbg(&pdev->dev, "error mapping memory\n");
206                 err = -EFAULT;
207                 goto err2;
208         }
209 
210         hcd = usb_create_hcd(&ehci_orion_hc_driver,
211                         &pdev->dev, pdev->dev.bus_id);
212         if (!hcd) {
213                 err = -ENOMEM;
214                 goto err3;
215         }
216 
217         hcd->rsrc_start = res->start;
218         hcd->rsrc_len = res->end - res->start + 1;
219         hcd->regs = regs;
220 
221         ehci = hcd_to_ehci(hcd);
222         ehci->caps = hcd->regs + 0x100;
223         ehci->regs = hcd->regs + 0x100 +
224                 HC_LENGTH(ehci_readl(ehci, &ehci->caps->hc_capbase));
225         ehci->hcs_params = ehci_readl(ehci, &ehci->caps->hcs_params);
226         ehci->is_tdi_rh_tt = 1;
227         ehci->sbrn = 0x20;
228 
229         /*
230          * setup Orion USB controller
231          */
232         orion_usb_setup(hcd);
233 
234         err = usb_add_hcd(hcd, irq, IRQF_SHARED | IRQF_DISABLED);
235         if (err)
236                 goto err4;
237 
238         return 0;
239 
240 err4:
241         usb_put_hcd(hcd);
242 err3:
243         iounmap(regs);
244 err2:
245         release_mem_region(res->start, res->end - res->start + 1);
246 err1:
247         dev_err(&pdev->dev, "init %s fail, %d\n",
248                 pdev->dev.bus_id, err);
249 
250         return err;
251 }
252 
253 static int __exit ehci_orion_drv_remove(struct platform_device *pdev)
254 {
255         struct usb_hcd *hcd = platform_get_drvdata(pdev);
256 
257         usb_remove_hcd(hcd);
258         iounmap(hcd->regs);
259         release_mem_region(hcd->rsrc_start, hcd->rsrc_len);
260         usb_put_hcd(hcd);
261 
262         return 0;
263 }
264 
265 MODULE_ALIAS("platform:orion-ehci");
266 
267 static struct platform_driver ehci_orion_driver = {
268         .probe          = ehci_orion_drv_probe,
269         .remove         = __exit_p(ehci_orion_drv_remove),
270         .shutdown       = usb_hcd_platform_shutdown,
271         .driver.name    = "orion-ehci",
272 };
273 
  This page was automatically generated by the LXR engine.