| Prev | Next | Start of Chapter | End of Chapter | Contents | Index | (5 out of 9)

Conclusion


The Conclusion block lets you perform these actions after drawing a conclusion:

It is especially useful after blocks that do not connect to action blocks, such as the AND, OR, and NOT gates.

Configuring

This is the configuration panel for the Conclusion block.


Attribute Description
Output Uncertainty
This attribute is for fuzzy logic, which NeurOn- Line does not support. If you want to use fuzzy logic and have GDA, refer to the documentation that came with GDA.
Status on Initialization
See "Specifying an Initial Status Value".
Hysteresis When
This attribute is for fuzzy logic, which NeurOn- Line does not support. If you want to use fuzzy logic and have GDA, refer to the documentation that came with GDA.
Description when True, Description when False, Description when Unknown, and
Description of Input
These attributes allow you to display explanations, which NeurOn-Line does not support.

Example

The figure below shows a Conclusion block connected to an AND Gate that concludes whether both the temperature of a tank is high and the volume of the tank is low. The Conclusion block is attached to a Rule Action block that writes a warning to the Message Board.


See Also

For more information on how to use this block, see the sections below.

Click here for more information...
Basic Block Behavior
Overriding Block Values

| Prev | Next | Start of Chapter | End of Chapter | Contents | Index | (5 out of 9)

Copyright © 1996, Gensym Corporation, Inc.