| Prev | Next | Start of Chapter | End of Chapter | Contents | Glossary | Index | Comments | (6 out of 12)

Locating Items in Your KB

 You can use the go to command to locate particular items in a KB. Issuing this command causes G2 to display the specified item at full scale in the center of the workspace with your cursor on the item.

The syntax is:

For example, the following command moves the cursor directly to valve-5:

Tip: You can accomplish the same thing by using the show on a workspace command, and then by using the go to original command on the item.

Note: If the item is already on the screen when you go to that item, G2 moves the workspace so that the item is in the center of the screen.

| Prev | Next | Start of Chapter | End of Chapter | Contents | Glossary | Index | Comments | (6 out of 12)

Copyright © 1997 Gensym Corporation, Inc.